ここから本文です
TWO:About three years later Sir Ralph Bardon died. He died of typhus caught on one of Reuben's insanitary cottages, where he had been nursing a sick boy. The village was inclined to look upon him as a martyr and Reuben as his murderer, but Reuben himself preserved a contemptuous attitude. "If I'd wanted anything as much as he wanted them houses o' mine, I'm hemmed if I wudn't have had 'em," he said, "and all he could do wur to die of 'em"and he spat.The Bardons were strongly anti-Corn Law, but their opposition had that same touch of inefficiency which characterised all their dealings and earned Reuben's contempt. In spite of their Liberalism they had been driven for financial considerations to inclose Boarzellthen even the inclosure had failed, and they were now, also against their will, surrendering the land piecemeal to a man who was in every way their opposite and antagonist. They agitated feebly for Repeal, but were unable to make themselves heard. They visited the poor, and doled out relief in ineffectual scraps. Reuben despised them. They were an old lineeffeteplayed out. He and his race would show them what was a Man.
Classification by type of system
1natural circulation external heating pipe type
2natural circulation calandria type
3forced circulation type
4falling-film type
5rising film type
6jacket type
7coil type
Classification by method of operation
1single effect evaporator system
2multiple effect evaporator system
3auto-vapor mechanical compression system
4auto-vapor ejector compression system
5multistage flash system

After taking into consideration of the physical and chemical property of solutions, the desired design conditions, and available utilities, we select the most suitable type of system by utilizing our years of experience and excellent results.
In addition, we can offer designs and manufacturing services that take into careful consideration compactness, energy-efficiency, and automatization.

THREE:Chapter 4

While standard calandria type evaporation systems are widely used as the typical concentration evaporator by the various food and chemical industries, we have delivered many of those systems as finishing concentration evaporators especially for sugar solutions and starch syrups.

THREE:Chapter 9
  • Enables flexible operation with little influence from variations in load and raw solution concentrations because of an adequate amount of solution being held within the system. These systems are also suitable for batch type burning evaporators.
  • Concentrations can be controlled within product specifications by the cascade control using the concentrations of concentrated solution and the raw solution supply and also by the arithmetic control of raw solution concentrations, etc. (Result for sugar solutions: 75±0.2wt%)
  • High-viscosity solutions and solutions that may crystallize can also be utilized by installing a propeller in the evaporator as a forced circulation system.
THREE:"How should I get free?"

This is a process example of a device that continuously and simultaneously concentrates two types of waste liquid with a single high-efficiency steam compressor.

THREE:The crest of Boarzell was just visible against the luminous sky. There was something sinister and challenging about those firs. The gorse round their trunks seemed in that strange half-stormy, half-peaceful night to throw off a faint glimmer of gold. The fiddle wept and sang into the darkness, and outside the window two cherry trees scraped their boughs together.
  • By evaporating the steam using a mechanical compressor and reusing it, almost no heating steam is alomost required except the time of start-up, so large energy savings can be expected.
  • By combining with a thin film falling heat exchanger that does not raise the boiling point due to the liquid depth, it is possible to utilize the temperature difference of the compressor at the maximum.
  • Since the residence time and heating time are short and the holding amount is small, starting and stopping can be performed in a short time.
  • It will prevent scale adhesion in the can that the evaporator is divided into two parts, and that the supply of the undiluted solution is alternately switched over a fixed period of time to perform heat concentration.